app_weld_adj_motion_offset()

def arc_sensing_model(left, right, time):
  
## Edit your own seam tracking algorithm in this function
  
# This example is assumed as below
# 1. Seam tracking algorithm is in welding machine
# 2. Use digital IO communication between robot controller and welding machine
  
    if left == 1:
        set_digital_output(15, ON)
    elif left == 0:
        set_digital_output(15, OFF)
              
    if right == 1:
        set_digital_output(16, ON)
    elif right == 0:
        set_digital_output(16, OFF)
      
    y_offset = 0
    z_offset = 0
    if get_digital_input(9) == OFF:
        y_offset = 10
        z_offset = 0
    if get_digital_input(10) == ON:
        y_offset = -10
        z_offset = 0
    if get_digital_input(11) == ON:
        y_offset = 0
        z_offset = 10
    if get_digital_input(12) == ON:
        y_offset = 0
        z_offset = -10
  
    offset=[y_offset, z_offset]
          
    return offset
  
def seam_tracking():
    Vt, Ct, Ft, velt, Vm, Cm, Off, Dout, status = app_weld_get_welding_cond_analog()
    if status == 99:
        left, right = app_weld_get_extreme_point(time=90)
        offset=arc_sensing_model(left, right, time)
        app_weld_adj_motion_offset(offset)  
          
set_velj(30)
set_accj(60)
set_velx(30)
set_accx(30)
  
movej(posj(0,0,90,0,90,0))
  
app_weld_enable_analog(ch_v_out=[0,0], spec_v_out=[0,0,0,0], ch_f_out =[0,0],
spec_f_out =[0,0,0,0], ch_v_in =[0,0], spec_v_in =[0,0,0,0], ch_c_in =[0,0],
spec_c_in=[0,0,0,0], ch_arc_on=0, ch_gas_on=0, ch_inching_fwd=0, ch_inching_bwd=0, ch_blow_out=0)
  
th_id = thread_run(seam_tracking, loop=True) #Activate Saem Tracking Function      
  
app_weld_set_weld_cond_analog(flag_dry_run=1, v_target=0, f_target=0, vel_target=10, vel_min=0,
vel_max=100, weld_proc_param=[0,0,0,0,0,0,0,0,0])
  
app_weld_weave_cond_zigzag(wv_offset=[-10,0], wv_ang=0, wv_param=[10,1])
# zigzag weaving pattern, offset=0,0 tilt angle=0, weaving width=10(mm), weaving period=0.5(sec)
  
app_weld_adj_welding_cond_analog(flag_reset=1)
movel(posx(619.50, -50, 982.80, 0, -180, 0), app_type=DR_MV_APP_WELD)
  
thread_stop(th_id) #Deactivate Seam Tracking Function
  
app_weld_disable_analog()