Slave Monitoring


1	Slave Type	Change the communication method for monitoring. You can select one among Modbus, Ethernet IP, or Profinet.
2	Ethernet Adapter Type	Check the Adapter Type of the currently configured Ethernet IP. The setting can be configured in the PLC menu of the Setting module.
3	Search	Search register data being monitored. The Value and Description containing the entered value will be the search targets.
4	Remove monitoring data	Remove data with activated check boxes. The number on the left displays the count of currently selected data and the total data count.
5	Add monitoring data	Add monitoring data. Up to 1,000 entries can be added.
6	Reorder	A button to change the order of data. Hold and drag the button to rearrange the data order.
7	Check Box	Select the data to be removed.
8	Data setting	Configure the group, address, description, and display method for the monitoring data. For Ethernet IP, the selectable mode changes according to the adapter type set in the PLC mode in the Setting module. For Profinet, the menu is fixed based on Monitoring & GPR.
9	Start/Stop Monitoring	This button allows starting or stopping the monitoring process. When monitoring starts, all fields except Slave Type, Search Box, and Description are disabled. Monitoring will end if the Stop Monitoring button is clicked, navigation to I/O Overview occurs, or the status module is closed. Monitoring cannot be started if there is no monitoring data for any Slave Type or if invalid data exists due to changes in the Ethernet IP's Adapter Type.