Setting Analog I/O Terminal (TBAIO)

To ensure maximum input accuracy, observe the following:

• Use shielded or twisted pair cables.

• Connect the cable shield to the ground terminal inside the controller.

• 
  

The electrical specifications of the analog I/O terminal are as follows:

• Depending on the output signal (voltage/current) of the device, it is necessary to set the controller analog input as “Voltage” or “Current” on the teach pendant.

• Depending on the input signal (voltage/current) of the device, it is necessary to set the controller analog output as “Voltage” or “Current” on the teach pendant.