Skip to main content
Skip table of contents

Remote Control Welder Forward/Reverse Inching Mode Change

Ramp or constant velocity mode can be selected by adding wire inching mode in forward/reverse inching.

Inching Mode Change

Interface Setting

Peripheral → Remote Control Welder Setting → Interface Setting Tab → 3. Test Signal Item → Set the wire inching mode based on the data sheet of the welder to use.

Signal Test Tab

It is possible to switch the modes during forward/reverse inching with the inching mode toggle key.

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.

Contact Support Close