Skip to main content
Skip table of contents

Connect Controller to Teach Pendant

.

Caution

  • Make sure to check that the pins in the cable end are not damaged or bent before connecting the cable.
  • When using the Teach Pendant hanging on the wall or controller, be careful not to trip over the connecting cables.
  • Be careful not to allow the controller, Teach Pendant or cable to come in contact with water.
  • Avoid installing the controller or Teach Pendant in a dusty or wet environment.
  • The control box and Teach Pendant must not be exposed to a dusty environment that exceeds the IP20 rating. Be especially careful in environments with conductive dust.

Note

  • When configuring the system, it is recommended to install a noise reducer to prevent noise influence among devices and system malfunctions.
  • If it is affected by noise generated by electromagnetic waves, it is recommended that ferrite cores be installed on the connection parts of the Teach Pendant cable to ensure normal operation. The installation locations are as follows:

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.