Skip to main content
Skip table of contents

Packaging Mode Setting

To configure the packaging mode, follow these steps:

  1. Tap the Safety Recovery button in the Status window.
  2. Select the Packaging Mode tab.
  3. Tap the Packaging Mode toggle button to enable Packaging Mode.
  4. Tap the Go to Packaging Pose button.
    • The robot automatically moves to the set packaging pose.
    • To release the packaging pose, tap the Release Packaging Pose button to move the robot to home position, then tap the Packaging Mode toggle button to disable packaging mode.


JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.