Skip to main content
Skip table of contents

End Effector I/O Signal Setting

  1. Tap the Add (
    ) Workcell button at the bottom of the end effector of the Workcell Manager.
  2. Enter the Workcell name in the Workcell Name field at the top of the Workcell Setting screen.

  3. Select the port number for I/O signal setting. Default Value displays the initial value set by the App Builder.

  4. Tap the Confirm button.


JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.