Skip to main content
Skip table of contents

Disengage the Password Lock

MANDATORY EASY 1 MIN 

When changing various settings after robot installation, the process can be troublesome as the system constantly requests the password to be entered.

In this case, enter the password through  Setting > Safety Password. If the system requests the password when the password is not changed, enter the following password.

  • admin

Touch the Password Lock toggle switch to disable the Password Lock function. Then all password lock functions will be disabled until the controller is rebooted.

Caution

  • Once the administrator finishes setting up the system, the password lock function must be enabled again before the user starts operating the system.

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.