Skip to main content
Skip table of contents

Automatic Mode

This is the mode in which the robot operates without direct user control. The robot will execute the programmed task or predefined sequence with a simple operation command and without additional user input.

Task Builder or Task Writer can verify the programed task in virtual mode, execute it in actual operation, and perform robot tool weight and auto weight center measurement functions.

  • If risk assessment results indicate that a 3-position Enable Switch is necessary, the 3-position Enable Switch can be connected through the I/O by the setting in the WCM > Robot > Safety I/O. In this case, the Enable Switch must be placed in the center-enable position to allow Play or Start, Resume and Servo On in Automatic Mode.
JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.