Skip to main content
Skip table of contents

Network Setting

To set the network, follow these steps:

  1. Tap the Settings button of the main menu and select Network.
  2. Select the Controller or Modbus tab.
    • Controller: Ethernet network settings for external connections such as the controller or Modbus can be configured.
    • Modbus: Additional settings for user-defined Modbus including Modbus TCP/RTU and additional settings for Preset Modbus used by some Workcell items can be set.
  3. Select the network method and tap the Confirm button.


주의

  • When setting IP address of the controller, the address in 10.0.0.X range which is used by assigning internally, cannot be used.
  • To be able to set and use DHCP in A-Series models, it is necessary to purchase an external router and configure a network.
JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.