Skip to main content
Skip table of contents

Network Connection

You can use laptops, TCP/IP equipment, Modbus equipment, etc. by connecting them to the network connection terminal in the controller.

Connect a cable to a dedicated port, depending on your network use.

  • WAN: Connecting external Internet

  • LAN: Connecting peripherals using TCP/IP or Modbus protocol

Plug the cable into the network connection terminal shown in the figure below to connect the network.

Caution

The LAN4 port is intended to connect to the internal controller, so do not connect any other equipment arbitrarily.

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.

Contact Support Close