set_modbus_output(iobus, value)
Features
This function sends the signal to an external Modbus system.
Function Code 05 Write Single Coil Register
Function Code 06 Write Signle Holding Register
Parameters
Parameter Name | Data Type | Default Value | Description |
iobus | string | - | modbus name (set in the TP) |
value | int | - | Value for Modbus coil register.
|
Value for Modbus holding register |
Note
When registered as a multiple signal, it is available by adding address value index to signal name.
Return
| Value | Description |
|---|---|
0 | Success |
Negative value | Failed |
Exception
| Exception | Description |
|---|---|
DR_Error (DR_ERROR_TYPE) | Parameter data type error occurred |
DR_Error (DR_ERROR_VALUE) | Parameter value is invalid |
DR_Error (DR_ERROR_RUNTIME) | C extension module error occurred |
DR_Error (DR_ERROR_STOP) | Program terminated forcefully |
Example
PY
#Modbus Coil Registers are registered as "do1" and "do2".
set_modbus_output("do1", ON)
set_modbus_output("do2", OFF)
#Modbus Holding Registers are registered as "reg1" and "reg2".
set_modbus_output("reg1", 10)
set_modbus_output("reg2", 24)
#Modbus multiple signal is registered as “multi”(start address=10, cnt=2).
#“multi_10” & “multi_11” abailable
set_modbus_output("multi_10", 24)
set_modbus_output("multi_11", 65535)