struct.CONFIG_DIGITAL_WELDING_ADJUST

This structure contains information for adjusting digital welding conditions.

• The _bRealTime member variable indicates whether real-time adjustment is enabled. 0 means preset mode, 1 means real-time adjustment mode.

• The _bResetFlag member variable indicates the reset flag. 0 means to keep the current value, 1 means to reset to the set value.

• The _fTargetVel member variable sets the target speed.

• The _fOffsetY and _fOffsetZ member variables set the weave Y offset and weave Z offset, respectively.

• The _fWidthRate member variable sets the weave width ratio.

• The _fDynamicCor and _fVoltageCor member variables set the dynamic correction and voltage correction, respectively.

• The _nJobNumber and _nSynergicID member variables set the job number and synergic ID, respectively.